32 of 64
CORRADI S.R.L.
- INSTALLATION MANUAL - PERGOTENDA ® MAESTRO
REV.1 - 11.2019
Fig. 38
-
Clean the areas of the casing and of the beam where the double-sided adhesive tape will be applied with the supplied wipe;
-
Press the bottle in the middle until it breaks then dampen the top of the block and apply;
-
Apply a strip of double-sided adhesive tape (A) with the same length of the cover casing (B) under the motor cable inlet slot;
- make the cover casing (
B
) perfectly adhere against the double-sided adhesive tape (
A
).
Note: in presence of EXPERIENCE lights (on the canvas), this “casing” must be installed exclusively after the lights installation in order to use the cable passage on the second slot of the
casing.
9 MOTOR CABLE INLET COVER CASING
A
B
B
When using EXPERIENCE lights, refer to the relevant manual.
