inside (5), chimney top (4), four chimney top sides (4), two chimney trims (5), four chimney flute fronts
(10), and four chimney flute sides (10).
4. Using tabs and slots as guides, glue the chimney sides to
the chimney front. Position the chimney front inside piece on
the inside of the chimney covering the two long “slots”.
Position and glue the chimney back inside piece to the
chimney back in the same manner. Glue the chimney top to
the chimney front assembly keeping it flush with the top edge
of front. Sandwich two chimney sides together by gluing and
glue to each side if chimney. Glue chimney back to front
keeping to edges flush. Position chimney trims on front and
back keeping top edges flush - glue.
5. Glue two chimney flute sides to two flute fronts, (making a
little box). Repeat for second flute. Position flutes on
chimney top and glue in place. Set entire chimney assembly
aside, do not glue onto house yet.
The Willow 5
D) ASSEMBLY OF FIRST FLOOR FIREPLACE/BOOKCASE WALL UNIT AND LEFT SIDE
CHIMNEY
1. R&P wall unit front (3), four bookcase sides (3), two wall unit sides (3), ten bookcase shelves (3),
two bookcase trims (3), two bookcase door trims (3), four bookcase doors (3), (these can either be
punched out and hinged, or left in place), fireplace mantel top (3), fireplace mantel bottom (3), two
mantel supports(8)two fireplace hearth floor pieces(3),four fireplace hearth sides(9),and the fireplace
hearth top.
2. Lay wall unit front face down. Glue wall unit
sides on to front keeping it flush to edge of front.
Using two bookcase sides and tow bookcase
shelves, create a “box”. Keep the shelves flush with
top and bottom edges of sides -glue. Position three
shelves however you choose inside this “box” and
glue in place. Position this entire assembly over the
bookcase opening on wall unit. Top and bottom
edges should be flush - glue, Repeat for second
bookcase. Turn wall unit over, glue bookcase trims
in place and then glue on bookcase doors and door
trims.
3. Glue fireplace mantel top to fireplace mantel
bottom. Position over fireplace opening using tab
and slot, glue in place. Position and glue mantel
supports under mantel on each end.
4. Glue the two hearth floor pieces together on top
of the other. With the hearth floor laying face up, glue the four hearth sides on TOP of the floor,
keeping outside edges flush, then glue the hearth top over the sides, again keeping outside edges flush.
Be sure to dry fit these pieces before gluing to be sure you have them positioned properly. Once
properly positioned, glue together. This assembly now needs to be glued to fireplace opening in the wall
unit front
5. Dry fit this entire wall unit assembly into house. Once proper fit is achieved, glue in place.
6. R&P left side chimney front (4), six chimney sides (4), chimney front inside (5), chimney back (5),
