CORNING PS-AU-AIR, Руководство по программированию для пользователя

Страница: 4 / 46

Corning Optical Communications
User Manual | Page 4
2. Preface
Warnings
All the following “Safety Precautions” must be observed during the entire installation and operation of the CrossFire
system.
The CrossFire system components are designed for maximum safety and reliability when they are installed, used, and
maintained by trained and qualified technicians following the procedures and instructions contained in this manual. To
assure the safe operation of your system, always follow the safety and operational recommendations in this manual.
⚫
PS-MP is not a consumer product. Please install and use PS-MP in accordance with the instructions.
⚫
Before installing or modifying any PS-MP equipment, read and fully understand the entire instructions in this guide.
⚫
Only qualified personnel are authorized to install and maintain the PS-MP.
⚫
Changes or modifications to the PS-MP equipment not expressly approved by the manufacturer could void the product
warranty and the user’s authority to operate the equipment.
⚫
Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.
⚫
Keep equipment powered-off during installing or modifying.
⚫
Low path loss cables connected to antennas are highly recommended.
⚫
This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS.
You MUST have an FCC LICENSE or express consent of an FCC License to operate this device. Unauthorized use may
result in significant forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
⚫
This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You
MUST have an ISED LICENCE or the express consent of an ISED licensee to operate this device.
⚫
To comply with FCC RF exposure compliance requirements, each individual antenna used for this transmitter must be
installed to provide a separation distance greater than
46
cm or more from all persons during normal operation and must
not be co-located with any other antenna for meeting RF exposure requirements.
Site Considerations
1. The system delay should be taken into consideration when there are neighboring BTS sites overlapping in coverage.
Normal use of the system will not damage the base station; however, with the increase of RU during network coverage
for indoor distribution, the uplink output noise level may affect the sensitivity of the base station, which should be
considered during engineering design. Pick an ideal easy-to-reach location for installation convenience.
2. Pick an ideal easy-to-reach location for installation convenience.
3. Verify that there is a minimum of a 50cm radius of space around CrossFire equipment for the convenience of
maintenance and on-site inspection.
4. Install CrossFire close to the service area for monitor and debugging.