STANDARD RECOMMENDED PROCEDURE 006-383 | ISSUE 1 | AUGUST 2008 | PAGE 10 OF 10
Corning Cable Systems LLC
√
PO Box 489
√
Hickory, NC 28603-0489 USA
1-800-743-2671
√
FAX +1-828-325-5060
√
Interna1-828-901-5000
√
http://www.corning.com/cablesystems
Corning Cable Systems reserves the right to improve, enhance, and modify the features and specifications of Corning Cable Systems’ products without prior notification.
<Registered Trademark> is a registered trademark of Corning Cable Systems Brands Inc.ClearCurve is a trademark of Corning Incorporated. CamSplice is a trademark of
Corning Cable Systems Brands Inc.All othertrademarks are the properties of their respective owners. Corning Cable Systems is ISO 9001 certified.
©
2008 Corning Cable Systems. All rights reserved. Published in the USA.
=
Step 1:
Remove Button B as shown using a 1/16-inch Allen wrench (Figure 20).
NOTE:
Rotate the cleaver’s orientation to prevent the blade from falling out of the cleaver.
Step 2:
Remove the Blade Capture Block using a 1/16-inch Allen wrench (Figure 21).
Step 3:
Use tweezers to remove the Blade Assembly.
Step 4:
Slide out the Blade Pin (Figure 22). Locate the replacement blade assembly from the
packaging and insert the Blade Pin into the new blade.
Step 5:
Using tweezers, place the new blade
assembly into the cleaver with the
blade facing toward the cleaver as
shown in Figure 21.
NOTE:
Be careful not to damage the blade.
Step 6:
Replace the Blade Capture Block
(Figure 21).
Step 7:
Replace Button B (Figure 20).
Step 8:
Clean blade per Section 8.2.
KPA-0998
Button B
Figure 20 — Remove Button B
KPA-2101
Blade Capture Block
Blade
NOTE:
Be
careful not to
overtighten
the screw in
the Blade
Capture Block.
Figure 21 — Remove Blade Capture Block and Blade Assembly
KPA-1000
Used
Blade
Replacement
Blade
Blade Pin
Figure 22 — Replace Blade
