ONE SD-LAN Wall
Mount Splitter Housing
(1LAN-SPLT-132-486C)
STANDARD RECOMMENDED PROCEDURE 000-000-AEN | ISSUE 1 | MARCH 2018 I
Page 9
Step 2
Remove the dust cap from the appropriate connector adapter. Clean each adapter before mating as
described in Section 9.
Step 3
Align the key on the connector with the key on the connector adapter. Install the connector into the
adapter.
Step 4
Record the connector terminations on the identification label inside the front cover (Figure 10) as
they are made.
Step 5
Close the front cover and secure it by tightening the external security screw with the can wrench
(approximately 15 in-lb torque).
9 Connecting End-Point Connectors after Initial Installation |
Step 1
Use a 3/8-in can wrench to loosen the external security screw and then depress the access latches
to open the door.
Step 2
Follow Steps 2 through 6 in Section 6 to connect end-points.
10 Connector Care and Cleaning |
WARNING
: Isopropyl alcohol is flammable with a flashpoint at 54ºF. It can cause irritation
to eyes on contact. In case of contact, flush eyes with water for at least 15 minutes.
Inhalation of vapors irritates the respiratory tract. Exposure to high concentrations has a
narcotic effect, producing symptoms of dizziness, drowsiness, headache, staggering,
unconsciousness, and possibly death.
•
Always keep dust caps on connectors and adapters when not in use.
•
Ensure dust caps are clean before reuse.
•
Use optical cleaning materials as standardized by your company.
•
Clean the connector before every mating, especially for test equipment patch cords (jumpers).
•
A minimum level of cleaning is listed below. Local procedures may require more rigorous cleaning methods.
Step 1
Remove plugs from the connector adapter.
Step 2
Wipe the connector ferrule twice with a lint-free wiping material moistened with isopropyl alcohol.
Then wipe across the end of the ferrule.
Step 3
Repeat previous step with a dry wipe.
