4
5
Connections
The Ci models are fitted with spring loaded terminals on the front baffle. Contacts will
accept up to 2,5 sq. mm wire with an outside diameter of up to 10mm.
Important: Always connect the red amplifier output (+) to the red speaker terminal in-
put and the black amplifier output (-) to the black speaker input. If reversed, the stereo
imaging will be blurred and the bass output will be dramatically reduced.
How to connect the cables
It is important that you run the speaker cables through the port BEFORE mounting
your new CORNERED speakers! The speakers are equipped with discreet cable termi-
nals placed on the front baffle behind the front cover – and it is not possible to run the
cables to the terminals once the speakers have been installed.
The Ci series can be mounted either in corners, on wall and ceilings with the integrat-
ed mounting points or the slider bars. They can also be coupled together to extend
coverage.
CORNERED top-boxes are very light, but please make sure that the wall or ceiling is
solid and can support the weight of the speaker before installing. Also, make sure that
you comply with all local health and safety regulations. The low weight and the sliders
allow the products to be installed easily by one person.
Vertical or horizontal installation in corners
If you prefer to mount the speaker in a corner, you should:
Getting started
Installation
2
1
2
Remove the front cover to access the cable terminal.
(push the cover from the side of the cabinet to squeeze it out of the grove).
Make sure the amplifier is turned off.
1
Remove the front cover and you’ll see the
mounting holes in the left and right hand
side of the cabinet.
Place the mounting template in desired position and mark drilling positions by shading
through the six mounting holes.
• Drill holes in the wall using 4mm raw plugs and the enclosed 3,5 mm flat head screws.
• Reposition the speakers in desired position and mount the screws.
Notes: Mounting in corners that are not exactly 90 degrees:
• If the corner is less than 90 degrees, simply place the speaker cabinet as deep in the corner
as possible and use all mounting points. This will leave a little space behind the cabinet and
the walls, but the speakers will still appear with a nice finish in the corner.
• If the corner is more than 90 degrees, we recommend mounting only one of the sides of
the speaker cabinet onto the wall – and leave some air behind the other side of the cabinet.
This will not be visible from the front, and the speakers will still present themselves with a
nice finish.
Run the speaker cable through the tube
positioned at the rear of the cabinet to the
terminal at the front baffle.
If you use the sliders, you can mount the
speaker cables to the terminal at this
point. If you use the mounting points, it
is easier to install the speaker first and
mount the cable to the terminal after the
speaker is mounted to the wall.
3
4
