Placement
Installation guide
•
3. Mount the speakers
The C3 is simply installed by screwing through the cabinet
•
Remove the front cover (you’ll see the two mounting
holes above and below the speaker units)
•
Place speakers in desired position
•
Mark drilling positions on the wall by shading through the
2 mounting holes
•
Drill holes in the wall and use 4mm rawlplugs and the
enclosed 3mm screws and washers.
•
Reposition the speakers in desired position and mount
the screws
•
Reinstall the front cover
Operation
Turn on the power by pushing the round switch in the top of the
cabinet. A blue LED light will come on and a voice will confirm
"P
ow
er on"
.
Push again to power off.
Connect to Bluetooth by activating BT on your device, Search for
"
CORNERED
A3
"
and connect. A voice will confirm "Connected".
If you wish to send a BT signal from another device, disconnect (a
voice will confirm "Disconnected") and connect from the other
device. The Cornered A3 will automatically reset any BT
connection when powered off.
Mounting the screws
1
Application examples
Vertical in corner
Vertical on wall
Horizontal in corner
Horizontal on wall
08
09
•
The Line input will override BT when
active
•
The tube allows for cables with a maximum diameter of 10mm
•
When connecting a passive speaker
use speaker cables with a
wire thickness of min. 1,5mm2
•
If the red amplifier output is connected to the black speaker input
(out of phase), the stereo imaging will be blurred, and the bass
output will be dramatically reduced
Important note:
