Cornell CFN- E160TRC, Руководство пользователя

Страница: 3 / 5

3
FAN BODY ASSEMBLY INSTRUCTIONS
1. Unscrew the spinner clockwise and the nut counter-clockwise to remove both of
them.
2. Set the rear guard in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Discard plastic sleeve on motor shaft.
5. Install the blade onto the motor shaft until it reaches the retaining pin.
6. Screw spinner onto motor shaft counter clockwise to blade.
7. Press the rim of the rear guard onto the front guard until the rear guard is properly
fitted.
8. Secure both guards firmly by tightening the fan guard then close easy clip.
FAN OPERATING INSTRUCTIONS
1. Once the fan has been assembled correctly connect the mains plug to the mains
socket.
2. To turn fan on press “ON/SPEED” on the control box or on the remote.
* When fan is on, it will start in low speed and the display shows “ ”.Repeatedly
press “ON / SPEED” to select the desired fan speed from 1 to 3.
3. To turn fan off press “OFF” on the control box or on the remote.
4. To make / stop the fan oscillate press “SWING” repeatedly
5. Tilt adjusting:
To adjust the air flow upward or downward, push the guard lightly to the desired
direction.
6. Mode
Press “MODE” repeatedly to select the desired wind mode. The corresponding light
will illuminate to show what wind mode you choose.
Normal wind Natural wind Sleep wind