ED/DF150 22” CCM322/522 Nordic Style Lid Kit Installation Instructions
Publication Number: 620204723INS
- 2 -
© 2007-2010, IMI Cornelius Inc.
6.
Seal the icemaker to the top of the dispenser as follows:
A. Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so
that the icemaker will set on the RTV.
B. Set the icemaker onto the lid and position it as required.
C. Wipe away the excess RTV.
7.
Drill 9/64” diameter holes into the icemaker cabinet using the bracket as a template. Use extreme care not to drill
into any icemaker components (condenser, tubing, etc.). Secure the brackets using the screws provided.
8.
Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8” diameter hole in the bottom of
the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of the wireform bracket and
wrap the tube around the end of the bracket several times, insuring the tube is secure.
NOTE: The bin stat must not interfere with the agitator rotation or in the path of ice falling from the ice-
maker. If it interferes with the agitator or in the path of ice, bend the bracket out of the way.
9.
If the plastic acorn nuts interfere with the positioning of the plastic manual fill cover, it may be necessary to make
small notches in the back flange of the cover to clear the acorn nuts.
10. The unit is now ready for operation.
Figure 1. ED/DF150 Kit
