9
4.
With the upper access panel raised, remove the hinge pin
from the top hinge.
5.
Remove the door from the hinges and screw the top hinge pin
back into the top hinge.
6.
Replace the upper access panel loosely on the ice maker.
7.
Reverse the door endcaps as follows:
■
Remove both the screws and endcaps (top and bottom).
■
Place the top endcap on the bottom of the opposite side
of the door with the long flat side facing the door front.
■
Place the bottom endcap on the top of the opposite side
of the door with the long flat side facing the door front.
8.
Set the door aside.
To reverse the hinges:
1.
Unscrew and remove the top hinge. Replace the screws in
the empty hinge holes.
2.
Remove the screws from the bottom of the opposite side of
the ice maker cabinet. Turn the top hinge upside down so that
the hinge pin points up. Place the hinge on the bottom
opposite side of the ice maker and tighten screws.
3.
Remove the plastic hinge pin sleeve from the “old” bottom
hinge and replace it on the new bottom hinge pin.
4.
Remove the “old” bottom hinge screws and hinge. Replace
the screws in the empty hinge holes.
5.
Remove the screws from the top of the opposite side of the
ice maker cabinet. Turn the hinge upside down so that the
hinge pin points down.
6.
Raise the upper access panel and place the hinge on the top
opposite side of the ice maker. Tighten the hinge screws.
7.
Remove the top hinge pin.
To replace door on hinges:
1.
Place plastic hinge pin sleeve in the top hinge hole on the
door. Align the door with the top hinge hole and replace the
top hinge pin.
2.
Replace the upper access panel and secure it with the hex
head screws.
3.
Replace the handle and handle screws.
Top Hinge
1. Hinge Pin
2. Hinge Pin Sleeve
3. Hinge
4. Hex Head Hinge Screw
Bottom Hinge
1. Hex Head Hinge Screw
2. Hinge Pin Sleeve
3. Hinge
4. Hinge Pin
To reverse the door catch:
1.
Remove the hole plugs from the opposite side of the door
and set aside.
2.
Remove the screws from the magnetic door catch and
replace it on the opposite side of the door.
3.
Push the hole plugs into place on the opposite side of the
door.
4.
Plug in ice maker or reconnect power.
Normal Sounds
Your new ice maker may make sounds that are not familiar to
you. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces such as the floor, walls and cabinets can make the
sounds seem louder than they actually are. The following
describes the kinds of sounds that might be new to you and what
may be making them.
■
You will hear a buzzing sound when the water valve opens to
fill the water reservoir for each cycle.
■
Rattling noises may come from the flow of the refrigerant or
the water line. Items stored on top of the ice maker can also
make noises.
■
The high efficiency compressor may make a pulsating or high
pitched sound.
■
Water running over the evaporator plate may make a
splashing sound.
■
Water running from the evaporator plate to the water reservoir
may make a splashing sound.
■
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your ice maker.
■
You may hear air being forced over the condenser by the
condenser fan.
■
During the harvest cycle, you may hear a “thud” when the ice
sheet slides from the evaporator onto the cutter grid.
■
When you first start the ice maker, you may hear water
running continuously. The ice maker is programmed to run a
rinse cycle before it begins to make ice.
