Cornelius ED 250 BCP, Руководство оператора

Страница: 13 / 18

Enduro Ice/Beverage Dispenser Operator’s Manual
© 2002, IMI Cornelius Inc. - 9 - Publication Number: 620916502OPR
TROUBLESHOOTING
IMPORTANT: Only qualified personnel should service internal components or electrical wiring.
WARNING: If repairs are to be made to the beverage system, remove quick disconnects from the
applicable product tank, then relieve the system pressure before proceeding. If repairs are to be
made to the C
O2
system, stop dispensing, shut off the C
O2
supply, then relieve the system pressure
before proceeding. If repairs are to be made to the ice dispensing system, make sure electrical
power is disconnected from the unit.
T
ROUBLE
P
ROBABLE
C
AUSE
R
EMEDY
NOTE: Should your unit fail to operate properly, check that there is power to the unit and that the
hopper contains ice. If the unit does not dispense, check the following chart under the appropri-
ate symptom(s) to aid in locating the defect.
BLOWN FUSE OR CIRCUIT
BREAKER. A. Short circuit in wiring (115V circuit). A. Replace defective wiring.
B. Defective agitator motor. B. Replace agitator motor.
SLUSHY ICE. WATER IN
HOPPER A. Blocked drain. A. Open-up/flush out drain.
B. Unit not level. B. Level unit.
C. Poor ice quality due to water quality
or ice maker problems.
C. Install water filter system. For
Icemaker problems, consult ice-
maker manual.
D. Improper use of flaked ice. D. Replaced flaked ice with “cube
style ice (see page 2, Unit
Description).
BEVERAGES DO NOT DIS-
PENSE. A. No 24 volt power to faucets. A. Check that beverage switch is
“on”. Check 24V transformers.
B. No CO2 pressure. B. Check CO2 regulator. Check
CO2 tank pressure.
BEVERAGES TOO SWEET. A. Carbonator not working. A. Check carbonator.
B. No CO2 pressure in carbonator. B. Check CO2 regulator. Check
CO2 tank pressure.
C. Faucet brix requires adjusting. C. Brix Faucet.
BEVERAGES NOT SWEET
ENOUGH. A. Empty syrup tank. A. Refill syrup tank.
B. Faucet Brix requires adjusting. B. Brix Faucet.
BEVERAGES NOT COLD
(UNITS WITH BUILD-IN COLD
PLATE). A. Unit standing with no ice in hopper -
no ice in cold plate cabinet.
A. Refill hopper with ice.
NOTE: Contact your local syrup or beverage equipment distributor for additional information and
trouble shooting of beverage system.
NO ICE DISPENSED FROM
ICE PORTION CONTROLLER A. Insufficient ice supply in ice bin. A. Replenish ice supply as
required.
B. Ice in ice bin bridged (stuck together).B. Gently tap on ice to break it
loose.
C. No electrical power to dispenser. C. Plug in dispenser power cord, or
check fuse or circuit breaker.
D. Insufficient or no CO2 supply to dis-
penser.
D. Restore CO2 supply to dis-
penser.
E. Ice chute cover not properly installed.E. Make sure that cover is
“snapped” into place.
F. Defective ice chute interlock switch. F. Replace interlock switch.
G. Defective interlock relay. G. Replace relay.