Install Computer
Locate a space under the dash to install the computer. Fasten to a flat surface utilizing flanges on unit.
Ground Computer Enclosure
Connect BLACK wire attached to computer enclosure to chassis ground. For Panasonic system, connect to camera
converter box. Ref. Dwg. C-02-99002
Connect Keypad
Route cable from keypad location to computer and plug into computer enclosure marked KEYPAD.
Interconnect Backup Camera
Disconnect backup camera cable at the monitor. Connect backup camera cable to one end of supplied video harness and
the other end to rear vision monitor. Then connect colored RCA jacks from video harness to TripTek computer enclosure.
If there are two camera ports on the rear vision monitor make sure you utilize the same connection as before.
For Panasonic system, disconnect backup camera cable (RCA) from converter and reconnect into TripTek computer
enclosure marked CAMERA. Take video cable that came with system and connect from enclosure marked MONITOR to
where cable was removed.
Connect Wire Harness
Take wire harness (noted above) and connect to computer enclosure marked DATA.
Fuse
Insert (1 Amp) fuse for chassis power (reference chassis power above).
Start Up
If there are any problems in the following start up process, refer to Appendix B Troubleshooting.
Turn the ignition key to the ON position, making sure the monitor is also turned on. An initialization screen should come
up first on the monitor. After 10 seconds it should turn off and the CHECKLIST screen should come up.
Sequence through the screens by pressing the view key and try all keys according to the operator’s manual. Also, while a
data screen is displayed, put coach in reverse – the data should turn off and the rear picture should be displayed.
Start the engine and check for proper operation of the display. If the display responds to the running engine by displaying
engine data, finish the installation. If the display does not work correctly, refer to Appendix B Troubleshooting.
Page 3
Содержание TripTek 2500 series
Страница 5: ...Drawing 02 99002 Installation Schematic...
