VC Setting:
•
VPI:
If you have uploaded a config file (see section 5.6 on page 39, this parameter will already be set. This is a value between 0-255 and is provided by your
Internet Service Provider (ISP).
•
VCI:
If you have uploaded a config file, this parameter will already be set. This is a value between 32-65535 and is provided by your Internet Service Provider
(ISP).
•
VPI,VCI Auto Detect:
If you have not uploaded a config file, and are not sure of the VPI and VCI parameters required by your ISP, then this utility will attempt
to determine the correct VPI & VCI parameters by examining the ADSL interface. (Make sure that the router is connected to the ADSL line if you use Auto Detect.
•
Encapsulation:
If you have uploaded a config file, this parameter will already be set. This will be set as either LLC or VC based, and is provided by your Internet
Service Provider (ISP).
WAN Connection
If you have uploaded a config file (see section 5-6), this parameter will already be set. WAN Connection type is the way the router works with DSLAM equipped in your
ISP side. This ADSL Wireless router supports six connection types listed as below. Different countries, and different operators use different types of connection type. It is
important to select the correct type for your network provider. If you are unsure about which WAN Connection Type, please consult your provider.
-
-
Gateway using PPPoE
-
Gateway using PPPoA
-
Gateway using Dynamic IP
-
Gateway using Static IP
-
Gateway using Classical IP (IP over ATM)
-
Modem using LLC Encap
3-1-1 Gateway using PPPoE
Figure 6. Gateway using PPPoE
•
Login Name:
Enter your ISP Username.
•
Password:
Enter your ISP Password.
•
Connect-on-demand:
Only enable this option if your ISP charges by the megabyte or by minutes (seconds) of line usage. Enabling this option will cause the
router to connect to the ADSL line when there is a packet waiting to be transmitted. Set the
Max Idle Time
with the length of time the router will remain in an
idle state before reconnecting to collect incoming data.
•
Keep Alive:
This function keeps your PPPoE connection always active even when there is no data to transmit. However, in some situations, the PPPoE session
cannot be built immediately after disconnection because the system on the ISP site may need a little time to restore. You may need to check with your ISP to find
out how much time is required before the router can start to re-build the PPPoE session and then fill this in the “
Redial Period
”.
•
Manual Connect/Disconnect
: Allows the user to manual connect or disconnect the ADSL connection from the keyboard.
• I
P Address:
This is the IP address of the WAN port. In most cases (default), this will be a
Dynamic
IP address. In some cases, this will be a
Static
IP address
issued by your ISP. If this is the case, select Fixed, and enter the IP address.
ENGLISH
8
