2
STEP-BY-STEP INSTRUCTIONS
This LED Flood light uses the latest in solid state lighEng technology for long life, low
maintenance, and high efficiency. The same as tradiEonal HID lighEng. An internal power-
factor-corrected switch-mode supply allows it to be used from any nominal 100-277V,
60Hz AC supply without any variaEon in light output. Suitable for use in the following
locaEons: ambient temperature of -20~+40°C and wet locaEons.
The fixtures can be installed using three installaEon methods, dependent on the model
you purchased: Direct mount to surface, mounEng with a slipfiger, and mounEng with
mounEng arm.
To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained
by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:
•
Be certain electrical power is OFF before and during installaEon and maintenance.
•
Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:
•
Make sure the supply voltage is the same as the rated luminaire voltage.
•
Do not install where the marked operaEng temperatures exceed the igniEon temperature of the hazardous
atmosphere.
•
Do not operate in ambient temperatures above those indicated on the luminaire nameplate.
•
Keep lens Eghtly closed when in operaEon.
WARNING
HOW TO DIRECT MOUNT TO SURFACE
1.
Use expansion bolts to secure the fixture on
mounEng surface.
2.
Keep enough length wires to ensure adjusEng
angle unhindered.
3.
Connect wires into wiring terminal; white wire to
“Neutral” terminal, black wire to “Live” terminal,
green wire to “Ground” terminal; and fix them by
screws.
4.
Restore the electricity and check the operaEon of
your new lighEng fixture.