Black wire RX-
Red wire RX+6.0V
White wire RX-Signal
PACE-45R’s indicating LEDs:
Conversion of Sensored and Sensorless function
* When the Power wires on the PACE-45R are connected with the battery pack, the PACE-45R can
automatically identify the motor type (Sensored/Sensorless) via indicated LEDs.
*If the PACE-45R works with the status of Sensored, if the Sensor wire is removed, the PACE-45R will
be automatically changed to the status of Sensorless.
Sensored/Sensorless PACE-45R ’s Indicating LED
Status of the function
INDICATED LED
Status of the LED
Zero Timing Mode
Red LED
Flashing, „Blinky‟
Over-heat of the PACE-45R and motor
(95
℃
)
Orange LED
Flashing
Sensored motor
Red and Orange LED ON
Sensorless motor
Orange LED
ON
Sensorless PACE-45R ’s Indicating LED
Status of the function
INDICATED LED
Status of the LED
Zero Timing Mode
Red LED
Flashing „Blinky‟
Over-heat of the PACE-45R and motor
(95
℃
)
Orange LED
Flashing
Sensorless motor
Orange LED
ON
Throttle Range Calibration (For the first time using transmitter or changing the transmitter
you must set Throttle Range Calibration)
1. Switch off the PACE-45R, then connect the PACE-45R with the battery and turn on the transmitter;
set the direction of the throttle channel to REV; set the EPA/ATV value of the throttle channel to 100%.
2. Hold the “Set” button and switch on the PACE-45R, wait for about 4 seconds until the Orange LED is
on solid, then release the “Set” button, apply full throttle until Red LED is on Solid and the motor beeps.
3. Apply Full Brake until the Orange LED blinks and will be on solid, the motor beeps.
4. Now return to Neutral, both of the Red LED and Orange LED blink simultaneously and will become
solid, the motor beeps, both of Red LED and Orange LED flash. The Throttle Range Calibration is
confirmed.
5. Turn off the PACE-45R.
6. Turn the PACE-45R back ON. The speed controller is now ready to use.