Focus Ring
135˚ Swivel Lens
LABELLING
INSTRUCTIONS FOR
SAFE USE
CorDEX Instruments Ltd. 1 Owens Rd, Middlesbrough, TS6 6HE, UK
TP2410 – Explosionproof Digital Camera
Ex d IIB+H2 T6 GbTamb -20°C to +50°C
ATEX –TRAC13ATEX0046X
IECEx :IECEx TRC 13.0016X
Serial Number- XXXX-XX-XXXX
Year of Construction- YYYY
Powered by – Refer to Manual
II 2 G
XXXX
DO NOT OPEN WHEN EXPLOSIVE ATMOSPHERE PRESENT
The conditions referenced in this section
relate specifically to hazardous area
applications and must be followed.
In accordance with clause 5.1 of EN 60079-1,
the critical dimensions of the flamepaths are:
•
Contact the manufacturer for information on
the dimensions of the flameproof joint
•
The apparatus must only be used in areas
where there is low risk of impac
•
Do not charge battery pack in the hazardous
are
•
The battery must be removed from the
camera and charged in the CorDEX
Instruments ToughPIX II charging bay part
number CDX-2400-XXX. Using a different
charging device will void the certification.
•
The ToughPIX II 2410 Series digital camera
incorporates a protected battery system
with a non-replaceable fuse. This fuse is
only to be replaced by CorDEX Instruments
or a CorDEX Instruments Approved Repair
Facility. Failure to do so will void the
certification.
•
Ensure that the ToughPIX II 2410 Series
digital camera battery pack is secured
using the plug provided. If the plug is lost,
only replace with a plug of the correct size
and type. If in doubt, contact your nearest
CorDEX Instruments representative.
•
The ToughPIX II 2410 Series digital camera
is manufactured from aluminium alloy; and
must contain less than 7% magnesium by
weight and incorporates toughened glass
windows. This should be taken into account
when considering the end use application.
•
TheToughPIX II 2410 Series digital camera
cannot be maintained in the field andmust
be returned to the manufacturer should
repair or maintenance be required.
•
USB communications with the ToughPIX II
2410 Series digital camera must only occur
within the non-hazardous area
•
When replacing the battery pack, the screw
must be re-tightened to a torque of 1.5-4Nm
and the cover cap replaced.
•
Only CorDEX battery pack CDX2400-011 shall
be use
Flamepath
Maximum
Gap (mm)
Minimum L
(mm)
Rearcarriage/
front carriage
0.04
6.5
Flash
Window/
frontcarriage
0.1
13.8
LCDWindow/
frontcarriage
0.1
13.8
Lens window/
frontcarriage
0.1
13.8
Operatingrod/
rear and
0.1
10.5
RUGGED
AUTHORITY
ToughPIX II
– Explosion Proof Digital Camera
5
