3. Replace the fender rail bolts with the supplied
stainless steel studs and one #P10162 spacer
and one #P10071 spacer on each stud, using a
5/8” wrench
(Figure 2)
. Tighten to 12 ft. lbs.
NOTE:
If using a sissy bar or trunkbox, you will
only be using one of the supplied spacers
(#P10162) on each stud.
(Figure 3)
4. Remove the foot peg using a 14mm socket
wrench.
(Figure 4)
5. Install the bottom mount bracket (#A00537 for
the left side and #A00536 for the right side),
between the frame and foot peg using the
supplied 8mm x 30 hex head bolts and flat
washers
(Figure 5).
Tighten to 10 ft. lbs. and
don’t forget the Loctite®
6. You are now ready to install the saddlebags.
Carefully align the bags with the three mounting
studs and secure the top two studs with a 5/16”
flat washer, lock washer and chrome acorn nut.
Secure the bottom stud with a 3/8” flat washer,
lock washer and chrome acorn nut. Tighten to 8
ft. lbs. and again, we recommend the use of
threadlock material.
NOTE:
If using a sissy bar or trunk box, remove
the cap on the saddle bag by unscrewing two
button head allen screws with a 3/32 Allen
wrench.
(Figure 6)
7. Repeat on the other side.
8. Installation is now complete, so get ready and
go for a ride!
FIG 3
FIG 2
FIG 4
FIG 5