Questions? Give us a call!
800-223-4332
FIG 7
FIG 9
FIG 11
FIG 13
FIG 8
FIG 10
FIG 12
FIG 14
8. Now carefully and neatly tuck the wires all away back
where it was.
9. Install the taillight bracket to the seat mounting
bracket
(Figure 10)
and secure with the supplied m8 x 40
cap screws, using a 6mm Allen wrench
.
Use Loctite®
and tighten to 10-12 ft. lbs.
NOTE:
Secure the hole in the rear first
(Figure 11)
, then
put your saddle in the upright position and secure the
front two bolts
(Figure 12)
.
10. Test the lighting to make sure everything works as it
should. Lighting should provide the following:
Running light
Brake light
11. Now go back and plug in your seat sensor and
reinstall the shock to your stock saddle.
12. Place your Corbin trunk onto the mounting bracket
(Figure 13)
and secure the four locations with the
provided m8 chrome flat washers and m8 x 25 chrome
button head Allen bolts, using a 5mm Allen wrench
(Figure 14)
. Tighten to 10-12 ft. lbs. and use Loctite®.
Remember to take care and use good judgement when
loading the Corbin trunk. Although it is capable of
handling a great deal of luggage, you do not want to
overload your bike or carry weight too high.
Enjoy the ride!