Corbin Russwin ASSA ABLOY MP6600 Series, Руководство по установке

Страница: 4 / 8

4
MP6600 Series
Installation Instructions
Multi-Point Lock
FM524 02/20
Copyright © 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
3 Installation
a Install Lockbody
Insert lock body into mortise cutout. Hold loosely in place with
(2) lock body screws.
Note:
Do not tighten screws fully at this time. (Figure 2)
b Assemble Outside Escutcheon
1. With outside lever horizontal, carefully insert mounting
posts through the door and lock body.
• Make sure spindle is properly engaged in the lock.
• Outside escutcheon assembly should be flush with
door surface.
If cylinder is not included in this function, proceed to Step 3c .
2. Screw cylinder into lock body until flush with
escutcheon face. (Figure 3)
c Assemble Adapter and Plate
1. Tighten retaining nut on inside of mounting plate and adapter as far
as it will go by hand, then back off retaining nut one notch until star
pattern lines up with square corners. (Figure 4)
2. Insert lever spindle into adapter and plate assembly so that it is held in
place. (Figure 5)
3. Insert inside adapter and plate assembly with lever spindle into square
hole on inside of door. (Figure 6)
4. Now tighten two screws on the inside adapter
and plate assembly. Do not over tighten. (Figure 7)
5. Tighten the lockbody screws. (Figure 8)
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6 Figure 7 Figure 8