5
Coral UV Sanitizer and Dryer
Before First Use
The Coral UV Sanitizer and Dryer is cleaned with alcohol wipes before packaging and might have an
alcohol smell when first opened. Before using your Coral UV Sanitizer and Dryer for the first time, we
recommend that you first run the product as described below.
To set up the product for normal use, follow these steps.
1.
Place the product on a flat, level surface with at least 5 inches (12.7 cm) of clearance between the
product and the wall.
This ensures proper ventilation clearance when the fan is running.
2.
Push the PRESS button on the front of the product to open the lid.
3.
Check that there is no damage to the bulbs. In the unlikely event the bulbs are damaged, please
contact us at
.
4.
Use a damp cloth and gently wipe the inside of the product.
Then u
se a dry cloth to ensure there
are
no water droplets remaining. Close the lid.
5.
Press AUTO until the time display shows 50.
If there is no noticeable difference, run another 50 minute AUTO cycle.
6.
After the cycle is complete, leave the product overnight with the lid open.
This is sufficient for first use. However, to freshen the product from packaging at the factory, place a
couple lemon or ginger slices in the chamber and run on AUTO for the longest cycle. See
