Coral 613, Руководство по установке

Страница: 5 / 8

- 5 -
Quick Set Up Guide
The main user guide should only be used for reference purposes, please use this guide
for initial programming.
Your Softener should already have been set up with the basic settings in the factory!
The only settings you should need to enter are the time of day, day of week and the water
hardness
1. Down arrow. Used to scroll down or
increment through a group of choices.
2. Set. Used to accept a setting to store in the
memory.
3. Up arrow. Used to scroll up or increment up
through a group of choices.
4. Regenerate. Used to command the controller
to regenerate.
Before starting this process ensure that the softener is connected correctly to the water and
power supplies.
Initial Power Up.
Plug the transformer into the rear of the control panel; this is located to the
left top corner of the panel if viewing from the front. Once the power is
connected the display should show 255, on occasions the display may
flash between time and regeneration with the regen symbol flashing, press
set button to clear. During the set up process the display may revert to
service mode (after 25 seconds) by repeatedly pressing the set button you
can scroll to the part of the set up programme you require. If you receive
an ERR3 message allow the cam shaft to turn for a few moments and this
code should disappear. If the cam does not move Check that the Cam
Shaft is fitted correctly and that the optical sensor is in position.
Set Time.
Press the set button. The TIME should now be flashing, use the up and
down arrows to set the correct time of day (24hrs format). Once the
correct time has been selected, press the set button to confirm. The
following will then be displayed.
Set Day of the Week.
Press the set button to display the screen shown. The display will flash,
use the up and down buttons to advance the arrow to underneath the
correct day. Once under the correct day press the set button to confirm.
The following will then be displayed.