2 2
GB
2
3
Assembly panel
WITHOUT table
First of all, check that both Floater elements
can be hooked in without any problems.
To do this, hook the panel into one of the
elements by placing the panel bracket on the
corresponding screws and then pressing/pus-
hing the panel downwards.
NOTE: If it is too difficult to hook in the panel,
unscrew the cylinder head screws slightly.
If there is a gap between the panel and the
element, screw the cylinder head screws in a
little further.
For final assembly, hook the panel into one of
the elements as described above.
The last step is to hook the other side of the
panel into the 2nd element using the same
procedure as described previously.
Finally, check that both connections are tight,
noiseless and that the panel does not move
back and forth.