TURNING ON /OFF:
1. Use thumb (or finger) to slide power switch locat-
ed on side of unit from “OFF” to “ON”
(see Fig. 3).
EMPTYING/CLEANING:
1. Remove base cover by pressing tab labeled
“PUSH” while tilting base cover downward to
separate it from upper housing (see Fig. 4).
2. Remove filter assembly by simply pulling it out of
upper housing. It will “snap” free to expose the
motor turbine.
Fig. 3
MAINTENANCE:
1. Empty debris particles from base cover into trash after each use for best
performance.
2. Completely remove base cover and filter assembly from unit for
cleaning. Rinse base cover and filter under warm water to clean
leftover particles and residue. Make sure cover and filter are
completely dry before reassembling.
3. Do not expose upper housing or motor components to water. These
components should be cleaned using only compressed air or a small
brush if needed.
4. If a decrease in cleaning performance is noticed, empty base cover,
check for blockages, and replace batteries if need be.
