3
Use shielded cables to connect the signal source to the amplifier input. To minimise the
possibility to hum the shielded cables should run parallel to each other or loosely twisted
together. Locate the cables away from speaker leads and AC power cords.
Selection of the proper gauge wire to connect the loudspeakers reserves the quality of sound
reproduction for which the loudspeakers has been designed. If undersize wire is used,
resistance is added to the amplifier/loudspeaker combination, which adversely affects the
performance. Added resistance causes reduction of the damping characteristics.
All connections is made on the back panel of the amplifier.
! "
The amplifier AC power cord is plugged into a 110/120/220/240 volt 50/60 Hz wall outlet. The
right voltage is indicated on the back panel just beside to the AC power inlet.
#
"
$
$ % ! "
&&%
The amplifier is on when the rotary switch is in vertical position.
The red LED will light up, indicating that power is on.
By turning the rotary switch anticlockwise, the amplifier will be turned off.
Содержание CTA506
Страница 1: ...1...