Copa FLOOR STANDING 26, Руководство пользователя

Страница: 34 / 40

When the indication on display screen is 24 hour,press the TIMER button again to delete the timed mode.
Sleep Operation
Replacement Of Bat teries
33
USER'S MANUAL
Set turning on time
Releasing procedure
Use this mode to reduce operation sound when sleeping,etc.
Press the SLEEP button,the air flow sound from the indoor unit is decreased.
Press the SLEEP button again can release the mode.
NOTE:
•
Use the sleep mode when you are going to bed.If this mode is used in the day,the capacity is reduced since the
ambient temperature is too high.(COOL MODE).
•
During the operation of cooling,the room temperature will be raised gradually by 2
0
C higher than the setting after
the machine begins to operate in the sleeping mode.
•
During the operation of heating mode,the room temperature will be dropped gradually 5
0
C lower than the setting
after the machine begins to operate in the sleeping mode.
•
When the signal from the remote controller becomes weak and the
indoor unit can not receive it properly;or the indications on the display
screen becomes blurred,please slide the back cover and replace with
two new batteries.
• The positive and negative poles must match the installation positions.
• New batteries of the same type have to be used for replacement.
• If the remote controller is not to be used for long time,take out the
batteries so as to prevent the leakage of the electrolyte from damaging
the controller.
•
If when the remote controller is at abnormal state,you can take out
the batteries on the back cover to clear off the display.
slide
the ba
ck co
ver
Remote Controller 2
and Remote Controller 3
Remote Controller 1
(push the RST button with the tip of a
ball pen,etc)
CLK RST
RST button
Unload the back Cover
This button let computer reset.
CLK button
It does not work on this model.
Set the time for the unit to turn on and when it is time,the air conditioner will automatically start operating.
1. When the air conditioner is in the standby mode, press the TIMER button and the air conditioner will enter the
timed switch-on mode.
2. Continuely press the TIMER button to set the needed time for switching on the machine. The timer can make
the setting in the range from 1-24 hours.Every the button is pressed,indication change is the following sequence:
1 * 2 * ........ * 24 *
cancel (no indication)
* 1.
3. After the setting of the timed switch-on, the digits shown on the display screen will go down by 1 for every elapsed
hour. The displayed digits indicate the remaining time prior to the timed switch-on.