![background image](http://html.mh-extra.com/html/coopers/key-finder/key-finder_instructions-for-use_2665168001.webp)
Remote Key Finder
10874
Instructions for Use
Please read and retain these instructions for future reference
v001: 15/05/17
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
USER INSTRUCTIONS:
Matching
Switch on the receiver and slide to change from OFF to ON (key tag). It will beep continuously. Push
button as indicated by “Press” on the side of the card, the receiver will emit a short beep once and
will then stop beeping which means the receiver (key tag) and card are matched.
Please push the button again if they are not matched at the first attempt.
Operation
Fit your keys to the matched key tag and put the card into your wallet or handbag. When you can’t
find your keys, just push the button on the side of the card, the key tag will beep for 5 seconds then
stop automatically. You can push it again and again until you find the lost keys.
Change battery
1x CR-2032 and 2x CR-2016 batteries are included.
1.
Receiver
: When the receiver sounds a low and strange beeping, it means the battery is low.
Insert a new CR-2032 button battery. Observe polarity, the “-“ face down to the PCB board.
2.
Card
: When you push the card’s button, but the receiver shows no reaction, and you can’t
see a red light at the hole on the the card’s back, then battery power is insufficient. Pull out
the battery drawer at the other side of the card, change the battery with 2 pcs of CR-2016
battery, and make sure both the 2 pcs “+” face the back of the card.
Troubleshooting
My key finder cannot be matched
Your card’s battery may not have enough power, make sure the card’s red LED is on when you are
pushing the card’s button, and match the receiver (key tag) with the card at 0.5 metre distance.
My key tag beeps continuously
The key tag will beep continuously before it is matched. The key tag will beep continuously, if you
keep pushing the card, so please don’t push the card after you find the keys. It will stop beeping
automatically 5 seconds later.
I pushed the button on the card, and the LED is working, why I can’t find the keys?
The keys may not be in this room, please try other rooms. And make sure it is matched before you
use it.