Rise & Recline Chair Massage 8 Point
G622
Instructions for Use
Please read and retain these instructions for future reference
v002: 22/05/20
Note: Backrest units are heavy and need to be lifted out evenly to avoid bending the metal plates. Care
should be taken not to strain one’s back when attempting to remove or refit a backrest.
Rise & Recline Chairs are fitted with a remote transformer block which is attached to a 13 amp plug. The
transformer block must not be allowed to dangle from a high socket. Always take care not to trip over the
block and keep it located in the safest possible position in a well ventilated, dry place on the floor where it
sits on its rubber feet. The transformer reduces the 240V mains power to a safe low voltage of just 24V.
•
Connect one end of the extension lead into the matching two prong slot in the transformer block
and the other end into the plug situated at the rear of the chair underneath the back flap, usually
held fast by a cleat.
•
Then connect the mains plug of the transformer into a suitable mains power socket and switch on
the power.
•
The chair should now operate when the handset buttons are pressed.
It is not recommended to use extension leads with this product but plug the electrical lead directly into the
socket.
Operating Instructions
Warning:
•
Always ensure that there is nothing to obstruct the free movement of the chair.
•
Before first use, the chair should be tested to ensure that all functions are working correctly.
•
Exercise care when lowering into the chair.
•
Do not sit on the arms.
Safety Cut-out
The motors are not designed for continuous operation. In the even that motors overheat, or the power limit
of motors is exceeded, a safety device will cut out the power.
If the chair does not restart after approximately 20 minutes, please contact Customer Services.
Adjusting the chair
Warning:
Take care when adjusting positions to avoid trapping or pinching of body parts.
When the chair is not in use it should be returned to the seated position.
