CD Radio Boombox
F907
Instructions for Use
Please read and retain these instructions for future reference
v001: 17/04/19
NOTE: The mains cable must be detached from the AC mains socket of the player for the batteries to
power the unit.
Leaking batteries may damage the battery cabinet and the player as a whole, so they should be removed
from the cabinet when becoming flat or when the player is not to be used with batteries for some time.
Mains operation
This unit is supplied with a DC mains cable.
1.
To connect the power insert the mains cable figure eight plug into the rear of the unit (16).
2.
Insert the UK plug into a household power socket and switch the power ON.
Power modes
Follow the below steps to power the unit off or enter standby mode.
1.
To power the unit OFF, slide the FUNCTION/RADIO BAND switch (15) to the OFF position.
2.
To enter STANDBY mode (power saving) press and hold the PLAY/PAUSE/ECO PWR button (11) for 5
seconds.
3.
To wake the unit from STANDBY mode press the PLAY/PAUSE/ECO PWR button (11) once.
AUTO STANDBY. Due to new ECO regulation requirements this product incorporates a power saving
feature.
When in CD mode once audio playback has ceased and the unit has stood idle for approximately 20 minutes
it will switch into a “power-down” power saving mode.
THIS IS NOT A FAULT.
To wake the unit up, press PLAY/PAUSE/ECO PWR button (11).
Volume control
1.
To increase the volume level rotate the VOLUME control (2) clockwise.
2.
To decrease the volume level rotate the VOLUME control (2) anti-clockwise.
CD operation
Load a CD
1.
Open the CD door by lifting the raised part of the lid (front above the display) upwards.
2.
Load a CD onto the disc tray with the label facing upwards you.
3.
Close the CD door.
Playing a CD
1.
Wake the unit from STANDBY mode if required.
2.
Slide the FUNCTION/RADIO BAND switch (15) to the CD/LINE IN position.
3.
Follow the steps above to load a disc (if not loaded).
4.
The player begins to read the disc immediately.
5.
When the disc is successfully read the total number of tracks found on the disc will be displayed.
6.
Press the PLAY/PAUSE button (11) once to begin playback. Press again to PAUSE the music playback, a
dot flashes on the display to indicate the player is in Pause mode. Pressing the PLAY/PAUSE button (11)
resumes playback.
7.
Press the STOP button (12) to cease music playback, the display shows the total number of tracks again.