Vertical CD Player G295 Instructions for Use
Please read and retain these instructions for future reference
v002: 15/05/20
Hints for Best Reception
The receiver has a build-in FM wire antenna hanging from the back of the cabinet. This wire should be
totally unwrapped and fully extended for the best reception.
NOTE:
Automatic tuning depends on the signal strength of the broadcasting station, so weak stations may
be skipped. You can manually tune to find the weak stations if a station gets skipped. With strong
signals, the tuner may stop before it reaches the actual broadcast frequency, so you may need to
manually tune for the best reception.
Hints
The unit with AUTO SEARCH function. In Radio mode, press SCAN Button, the unit will scan from
lowest frequency to highest frequency in the selected frequency band. Those radio stations were
found will be stored in the preset location start from P01.
Note:
1.
There is a 5 seconds delay when programming, after 5 seconds, the unit will automatically
switch back to normal tuner mode.
2. You can overwrite a present station by overwriting and storing the new frequency in its place.
PRESET RADIO STATIONS
1.
Press the
STANDBY
Button
on main unit or remote control to turn on the unit.
2.
Tap the
MODE Button
on main unit or remote control to select FM radio mode.
3.
Tune to the desired radio station either by “manually” or “automatically” tuning method.
4.
Tap the
MEM.
Button
on remote control to turn on the unit, the next available preset memory
number flash in the LCD display. (Note:”P01” will blink in the display if you are programming preset for
first time)
5.
Tap the
PRESET
+ or
-
Button
on remote control to select the preset number you want to assign the
station to.
6.
Tap the
MEM. Button
on remote control to confirm the setting.
7.
Repeat above steps 3 - 6 to preset up to 20 FM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the
PRESET
+ or
-
Button
on remote control
repeatedly.
CD DISC OPERATION
DISC PLAY MODE
1. Press the STANDBY button on the remote control or ON/OFF button to turn on the power on.
2. Press MODE button on the remote control or CD/USB button to turn on the CD mode.
3. Open the CD DOOR by pressing the CD DOOR at the “OPEN/CLOSE” mark located on the CD door, load a
CD with the label side facing upward and then close the CD door.
4. CD playback will start from track 1 once the Player has finished reading the TOC. The PLAY INDICATOR
will appear steadily on the LCD DISPLAY.
5. While playing, press the PLAY/PAUSE button to pause, the PAUSE indicator will appear steadily on the
LCD DISPLAY. Press the PLAY/PAUSE button again to resume playing.
6. Adjust the volume using the VOLUME control.
PROCEDURE TO PLAYBACK MP3/WMA DISC
To play back CD-R/RW
