WARNING
• Please do not place hands near hinges when opening
the bed.
• Please be careful when opening and closing the bed as
safety lock may cause potential harm to the user.
• The recommended weight load for this bed is 100kgs
(15st 10lb).
TECHNICAL SPECIFICATION
Measurements in box: H102cm xW86cm xD36cm
(40in x33in x14in).
Folded out: L191cm xW78cm xH34cm (75in x30in x13in).
DISPOSAL
• Dispose of all paper, cartons and plastic in accordance
with your local recycling regulations. At the end of the
product’s lifespan please dispose of it at an authorised
household waste recycling centre.
6. Take 1x front panel (M) and attach 8x drawer knobs (j) with 8x drawer knob bolts (g)
using a screwdriver.
7. Attach the front panel (M) and the two side panels (N) so that the dowel pins (a) and
cam bolts (b) align. Carefully secure all three panels together in place with 4x cam
locks (c) using a screwdriver.
Please note this part of the assembly may require two persons.
8. Attach the top panel (L) and the two side panels (N) and front panel (M) so that the
dowel pins and cam bolts align, carefully secure in place with 4x cam locks (c) using
a screwdriver.
Please note this part of the assembly may require two persons.
9. Carefully position the bed frame on its side
and insert 2x long rear castors (f) plus 2x
spacers (i) into the bed frame as shown.
Insert 2x short front castors (e) into the bed
frame as shown. Secure in place with 4x nuts
(h) for each castor with a spanner. Please
note that you will need to insert 1x spacer (i)
over each rear castor (f) before inserting it
into the bed frame.
10. Carefully reposition the bed frame (O) so it
sits on all 4 castors, release the safety lock
(q) and open the bed fully. Place the bed
frame against the inside of the constructed
mock drawer front. Insert 4x base panel
bolts (d) through the outside of both side
panels (N) and into the frame of the bed.
Secure in place with 4x nuts (k) and tighten
firmly with a spanner.
Please note this part of the assembly may require two persons.
11. Close the bed frame and mattress (P) and secure in place with the safety lock. Your
bed is now ready to use. Position the bed in the desired location.
Long rear castor
Base panel
bolt being
secured with nut
Short front castor
