10
Cooper Lighting Solutions
Installation instructions
Digital Wall Switch Timer
SETTINGS
•
The tamper resistant time-on interval can be preset. In addition, a manual scroll-up mode can override the setting tempo-
rarily – this feature can be disabled, thereby providing a fixed interval timer.
• A flicker of the lights and/or a beep warning begins 2 minutes before time-out (either or both can be disabled). This docu-
ment covers installation of the following products.
The TSW-MV is factory preset to meet newer energy code override mandates. No adjustment is required. This setting
will provide a two hour maximum operating time before shut off. The scroll feature is active to allow the user to change the
operating time with the maximum time setting at two hours.
Close the timer door and the unit is ready. One press of the bottom cover turns the load ON. The load will stay ON until a
count-down to the preset OFF time. Pressing the bottom cover again will turn load OFF.
SET FOR:
1.
4HR: Set ON for preset 4 hour maximum count-down when 2HR is set to OFF. (Also used in custom time programming.)
2. 2HR: Set ON for preset 2 hour maximum count-down when 4HR is set to OFF. (Also used in custom time programming.)
3. LIMIT: Used with programming sequence. Switch from ON to OFF to limit scroll to match custom time.
4. SCROLL: Set ON allowing the timer to scroll to a shorter run time. Set OFF to disable. Switch from ON to OFF to set a
custom time. (Also used in programming sequence.)
The time scrolls in steps:
•
5 minute steps from 5 minutes to 1 hour.
•
10 minute steps from 1 to 4 hours.
•
30 minute steps from 4 to 12 hours.
•
1 hour steps from 12 to 24 hours
5.
BEEPER: Set ON activating the feature for a beep warning every 15 seconds starting 2 minutes before OFF.
6.
BLINK: Set ON activating a feature for load flash 2 minutes before OFF.
“ “= Beeper
“ “ = Blink
RESET BUTTON
TIMER BUTTON
ON - SWITCH UP
OFF - SWITCH DOWN
