CAUTION:
MOUNT THE RFWGT A MINIMUM OF 5 FEET FROM THE
FLOOR TO KEEP IT OUT OF THE REACH OF SMALL CHILDREN.
With new installations, the RFWGT should be programmed before
mounting to the wall.
1. Choose a convenient location that does not interfere with the
normal opening and closing operation of the door, such as door
jamb, but is within sight of the door.
2. Two screws are included for proper mounting into wood or
other similar material. A 5/64” x 3/4” pilot hole may need to be
drilled for the mounting screws. If mounting to other materials
consult a qualified building or hardware specialist for the proper
hardware to insure secure mounting.
3. Insert upper screw into upper pilot hole leaving head of screw
1/16” away from wall as shown in the illustration to the left.
4. Slide and lock back keyhole slot over exposed screw and
position unit vertically.
5. Remove battery door to expose lower screw mounting hole.
6. Insert lower screw and tighten.
7. Replace battery door.
To OPEN, CLOSE, START, and STOP your garage door opener.
1. Activate your keypad by pressing the ON/OFF/RESET button.
The keypad will illuminate.
2. Enter the 4-digit PIN (personal identification number) for the
garage door opener you want to operate. The garage door
opener will begin to move the door.
NOTE:
The garage door opener will not move the door if the
incorrect PIN is entered. Reset the RFWGT by pressing the
ON/OFF/RESET button and enter the correct PIN.
3. The RFWGT will remain active for 15 seconds, pressing any key,
except the ON/OFF/RESET button will stop the garage door
opener from opening the door, and will stop and reverse the
direction if it is closing the door.
4
RFWGT
WIRELESS
KEYLESS
ENTRY
LOWER SCREW
MOUNTING HOLE
LOCATED BEHIND
BATTERY COVER
Mounting the RFWGT
RFWGT Operation with Garage Door Opener
LEAVE UPPER
SCREW HEAD AWAY
1/16” FROM WALL
1/16”
ON/OFF/RESET
USE KEY PAD
TO INPUT
4-DIGIT PIN CODE
2
1
All manuals and user guides at all-guides.com
