P82697 K
Sheet 2 of 4
INSTALLATION INFORMATION:
There is a slotted shaft, underneath the cable entrance interface adapter, which operates a 7-position selector switch. Remove the
interface adapter and set the switch for the desired wattage at the specified speaker line voltage (25V or 70V). Adjust the switch by
turning the slotted shaft until the end of the slot which is opposite the flat on the shaft points to the desired number. The wattage
provided at each selector number is shown on the decal affixed to the rear of the housing.
MOUNTING INFORMATION:
The horn speakers may be wall mounted by simply using the holes in the swivel base to locate and drill mounting holes. Mount the
base to the surface with appropriate hardware. Slots are also provided in the base for banding straps, to allow mounting to beams,
poles, and girders. The mounting base is also fully adjustable in both the vertical and horizontal planes (See Figure 1).
CAUTION:
These devices are not intended for use in hazardous locations as defined by the National Electrical Code (NEC) and
by the National Fire Protection Association (NFPA).
Figure 1:
MOUNTING ARM
SWIVELS
OVERHEAD VIEW OF
MOUNTING BASE
(SHOWN WITHOUT
HORN)
WING NUT FOR ROTATION AND
SWIVEL ADJUSTMENTS
BASE ROTATES 360 DEGREES
BANDING SLOT (2)
MOUNTING HOLE (3)
NOTE
: Loosening the wing nut will allow for both pitch and rotation of the unit.
CAUTION:
When adjusting horn position, be careful not to lose adjusting hardware.
The interface adapter (mounted to the horn) permits conduit connection. The interface adapter is threaded for standard 1/2" pipe, and
will accommodate BX cable, flexible or rigid conduit and matching connectors. The interface adapter is shown in Figure 2 below.
Figure 2: Interface Adapter
