2
496573 Issue 1
5.
Press
..
6.
Key in the new access code again.
7.
Press
..
The keypad beeps twice and flashes the red LED to indicate that it has
accepted the new code. If the keypad gives a low error tone then it has
not accepted the new code, and not changed the current code. Repeat
steps 1 to 7.
Setting, Part Setting and Unsetting
To Set your Alarm System
Key in the Access code and press
.
To Part Set your Alarm System
Key in the Access code and press
.
To Unset your Alarm System
Key in the Access code and press
.
To Start a PA Alarm
Press
and
together.
Resetting After an Alarm
For a 500r+ Alarm System:
Go to the control unit and follow the procedure in the 500r+ User Guide.
For a 690r Alarm System:
Key in the Access code and press
.
Yellow LED Flashing
If the keypad flashes the yellow LED (see Figure 1) while you are using it
then its battery is low.
In case of problems contact your installer.
Installer Tel. No.:
