COVER
RING
BACK RING
COIL SPRING
LAMP
(MR16 shown, COIL
SPRING behind)
BACK RING
SOCKET ASSY
PIVOT JOINT
(FOR GIMBAL
TIGHTENING)
OPTICAL
ACCESSORY
ACCESSORY
RETAINER
RING
COVER
RING
SNOOT
Flush Position
Regressed Position
CEILING
LINE
11. Lamp installation:
To install LAMP, remove the COVER RING by pushing straight back on
the COVER RING and then turning it
counter-clockwise
to release.
See Fig. 5.
12. Once removed, insert the properly-specified LAMP into the
BACK RING, ensure that the LAMP is the correct LAMP for the SOCKET
or damage to the fixture or lamp may occur. The LAMP will seat into the
COIL SPRING when installed properly. While holding the LAMP in place,
grab the SOCKET ASSY and plug or screw the LAMP firmly into it.
See Fig. 6.
Figure 7
Figure 6
(Cover Ring Removed)
Figure 8
Figure 5
13. Optical Accessory: (skip to Step 21 if not using optical accessories)
To install OPTICAL ACCESSORY pieces, remove the ACCESSORY
RETAINER RING by unthreading until it is completely removed from the
COVER RING.
14. Install desired OPTICAL ACCESSORY pieces into the COVER RING and
re-thread the ACCESSORY RETAINER RING firmly. See Fig. 7.
*The COVER RING can accommodate three (3) accessories without the
ACCESSORY RETAINER RING or two (2) pieces with it.
*The ACCESSORY RETAINER RING may be used to lock the accessory.
For example, a linear spread lens or cross baffle can be locked in-place
into a desired orientation.
*Please note that not all accessories are compatible with each other and
with all lamps.
15. Regressed Lamp Ring/Snoot: (skip to Step 19 if not regressing the lamp)
The lamp ring may be installed in a regressed position only if a
SNOOT accessory is being used. See Fig. 8. If necessary, please see step
13 for instructions on SNOOT installation. To accomplish the regressed
lamp ring position set the COVER RING aside. Remove the lamp ring assy
by loosening the two (2) SET SCREWs in the GIMBAL BLOCKs.
16. Once loosened the lamp ring assy can be removed by grasping the
GIMBAL RING and turning
clockwise
until it releases from the GIMBAL
BLOCKs.
INSTALLATION INSTRUCTIONS
V90229-2
Avoid Fire or Electric Shock
COMBOLIGHT
LAMPHOLDER
Page 2 of 3
THIS PRODUCT MUST BE INSTALLED IN
ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
*Installation Instructions for qualified electricians only.
*Install per National Electrical Code and local regulations.
*Read Installation Instructions completely before installation.
*Failure to follow Installation Instructions may void warranties.
R
