Cooper Controls EG2, Руководство по установке, Страница: 7 / 8

P
7 Document 9850-000224-00 EG2
Change IP address via the Ethernet port
EG2 is supplied from the factory without DHCP enabled; therefore, it is necessary that the
Ethernet port of the PC is set to the correct IP Address and Subnet Mask. For details of
setting the IP address of your computer consult information on line. This will depend on your
Operating System.
For example:
IP Address 192.168.0.99 •
Subnet mask 255.255.255.0 •
Gateway 192.168.0.1 •
To connect the EG2 directly to the PC, it may be necessary to use a Crossover Cable,
however, most modern computers are able to connect directly to another Ethernet device
without a crossover cable.
The Ethernet port of your computer will need to configured to a compatible IP address.
Open iCANsoft. It will be required to set iCANsoft to communicate using the Ethernet Port.
This is done by selecting from the Tool bar Tools>Options>Network.
Select Ethernet Gateway and change the IP address to 192.168.0.100. Also ensure the ‘Use
Password’ check box is ticked. The detault password is Cooper123 (Case sentitive).
Select OK to confirm and set the
address.
iCANsoft can now be used to configure
any items connected on the network.
Set the IP address of the EG2 as
described in section above for
iCANsoft. The new IP address will
become valid when the EG2 is reset
or power to the device is removed and
re-instated.
Reset to factory defaults
Factory defaults may be reset by the following procedure:
Remove power from the board.
Press the CAN ID button and reapply power. Keep the button pressed until the CAN LED
flashes then stays on. At this point the Ethernet settings will have been restored to defaults.
After setting to factory defaults, the IP address of the device will revert to 192.168.0.100