12
Introduction for buttons on remote controller
P
ress this button to achieve the on and off of healthy and scavenging functions in
operation status.Press this button for the first time to start scavenging function;
LCD displays“ ”. Press the button for the second time to start healthy and scavenging
functions simultaneously; LCD displays“ ” and “ ” . Press this button for the third
time to quit healthy and scavenging functions simultaneously. Press the button for the
fourth time to start healthy function; LCD display “ ”. Press this button again to repeat
the operation above.
/
8
SLEEP:
9
Press this button, can select Sleep 1 ( ), Sleep 2 ( ),Sleep 3 ( ) and cancel
the Sleep,circulate between these, after electrified, Sleep Cancel is defaulted.
Sleep 1 is Sleep mode 1, in Cool, Dehumidify modes: sleep status after run for one hour, the
main unit setting temperature will increase 1
Sleep 3- the sleep curve setting under Sleep mode by DIY:
(1) Under Sleep 3 mode, press “Turbo” button for a long time, remote control enters into user
individuation sleep setting status, at this time, the time of remote control will display “1hour “,
the setting temperature “88” will display the corresponding temperature of last setting sleep
curve and blink (The first entering will display according to the initial curve setting value of
original factory);
(2) Adjust “+” and “-” button, could change the corresponding setting temperature, after
adjusted, press “Trubo “button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer postion on the remote
control, (that are “2hours “ or “3hours “ or “8hours “), the place of setting temperature “88”
will display the corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2)
～
(3) operation, until 8hours temperature setting finished,
sleep,curve setting finished, at this time, the remote control will resume the original timer
display;
temperature display will resume to original setting temperature.
●
●
Sleep3- the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting sleep curve,
enter into user individuation sleep setting status, but do not change the temperature, press
"Turbo" button directly for confirmation.Note: In the above presetting or enquiry procedure,
if continuously within10s, there is no button pressed, the sleep curve setting within
10s, there is no button pressed, the sleep curve setting status will be automatically
quit and resume to display the original displaying. In the presetting or enquiry procedure, press
●
●
℃
,setting temperature increased 2
℃
, the unit will
run at this setting temperature; In Heat mode: sleep status after run for one hour, the setting
temperature will decrease 1
℃
, 2 hours, setting temperature will decrease 2
℃
, then the unit
will run at this setting temperature.
●
Sleep 2 is sleep mode 2, that is
heat
pump
will run according to the presetting a group of
sleep temperature curve.
"ON/OFF" button, "Mode" button, "Timer"button or "Sleep" button, the sleep curve setting
or enquiry status will quit similarly.
