Cooper & Hunter CH-D009WD8-20LD, Руководство пользователя

Страница: 24 / 47

24
COMFORT
When the dehumidifier is set to “Comfort” mode, the wind speed is set to low, the humidity
is set to 60%, and the indicator light is green.
ANION:
When set
“ANION”, the anion button will turn green.
5 OPERATING INSTRUCTIONS
1. When the substrate is powered on for the first time, the substrate enters the standby
state, press the power button to enter the running state, and the first power-on and start-up
operation is continuous dehumidification, the motor runs at low speed, the continuous
dehumidification indicator lights, if it is turned on again after the power is off, Humidity
setting before memory shutdown.
2. Press the humidity mode button, the humidity can be switched between 70% 60% 50%
40% continuous dehumidification, the corresponding indicator light is on, if the set humidity
is greater than the current ambient hu5%, the machine will stop working after 5
seconds. When the set humidity is lower than the current ambient temperature, the
machine will work normally.
5.1 DEHUMIDIFYING RUNNING
1.
When the compressor has passed the protection for 3 minutes and the indoor humidity ≥
set hu 5% RH, the compressor will work again.
2. When the indoor humidity < set humidity - 5% RH, the compressor is turned off.
3. Set the humidity - 5% RH < indoor humidity < set hu 5% RH to keep the original
compressor working.
4. The compressor stops the fan if it has not been operated for three minutes after the
humidity has dropped.
5. When the machine beeps three times and the water full indicator light is on, the machine
stops working. The water in the water tank needs to be drained and the water tank is
reinstalled. If the water full indicator light is still on, check whether the water tank is in place.
The operation is started until the water full indicator is off.