7
7
Electrical connection
Once the gas supply has been connected, plug the hob into the 3-pin socket, and switch the socket ON.
Preparation
1.
Remove the remnants of any stickers, glue and adhesive tape from the surfaces of the hob and the
burners, with warm water and washing-up liquid.
2.
Ensure that all elements of the burners are positioned correctly.
The hob is now ready for use.
Gas supply connection
PLEASE NOTE: Connection of the gas supply, adjustment, cleaning and tap servicing should ONLY
be carried out by a CORGI registered gas fitter or qualified service engineer, in accordance with the
latest regulations.
There are two installation options:
Connection to natural gas supply
The hob comes ready for connection to a piped supply of natural gas, and should only be connected by a
CORGI registered gas fitter or qualified service personnel, in accordance with the latest regulations.
Before connecting the hob to the gas supply system, ensure that the appliance is compatible with the local
distribution conditions (nature of the gas and gas pressure). In the event of incompatibility, consult a CORGI
registered installer to make the necessary adaptations or adjustments.
Connection to an LPG cylinder
Alternatively, the hob can be connected to an LPG cylinder. In this case, the LPG injector jets (supplied)
should be fitted by the qualified service engineer. Use a rubber hose with a safety certificate to connect the
applicance to the LPG cylinder.
Every time the hob has been connected to an LPG cylinder, check the cylinder valve for soundness and the
connection of the regulator to the cylinder and also its operation.
WARNING: Under no circumstances should the gas tightness be checked by means of a naked
flame (e.g with a match or candle) as there is a danger of explosion.
WARNING: Before starting any adjustments or changing the injectors, disconnect the appliance
from gas and mains electricity supply.
