Page 4
Door reversal
This appliance has the facility to hang the door on the opposite side.
The doors on the housing unit must have the hinges on the same side as the fridge freezer.
Depending upon where you plan to locate the fridge freezer, reversing the door may make access more
convenient.
1.
Pull off the blanking plates either side of the control panel. Unscrew and remove the two hinge screws.
Lift away the hinge and top door (Figure 2).
2.
Undo and remove the centre hinge pin and washer. Lift away the lower door (Figure 3).
3.
Upturn the hinge and fit it to the opposite side of the appliance, not forgetting the washer.
4.
Undo the lower hinge pin on the lower bracket and then release the bracket by removing the bracket
screws (Figure 4).
5.
Replace the hinge pin in the opposite hole in the bracket and fit the bracket to the other side of the
casing with the bracket screws (Figure 5).
6.
Replace the doors and respective blanking plates in reverse order following steps 1 and 2, above.
FIGURE 2
BLANKING
PLATES
HINGE
SCREWS
FIGURE 3
CENTRE
HINGE
PIN
WASHER
BRACKET
SCREWS
FIGURE 4
LOWER
HINGE
PIN
LOWER
HINGE
PIN
LOWER
BRACKET
LOWER
BRACKET
BRACKET
SCREWS
BRACKET
SCREWS
FIGURE 5
