background image

Installation Instructions:

With the power switch on the remote controller in the OFF position and the cooling switch of the 

remote controller in the zero percent (0%) position:

1)

Secure the main cooling unit and the remote controller in the desired locations of the

vehicle (appropriate hardware not supplied).  In selecting the placement, secure the

cooling unit and the remote controller in a structurally sound area of the vehicle where

it can be secured in such a manner that it will stay secured in the event of an accident.

Ensure that there is at least 4” of clearance on all sides of the main cooling unit.  Do

not place the ProCool-R system in the same compartment as the fuel cell.  Place the

ProCool-R system in a driver’s compartment for best air exchange.

NOTE:  Ensure that the COOLSHIRT® 8-foot water hose can reach the driver.  

Do not allow the hose to come into contact with any hot metals as this may damage the hose.

2)

Connect the Deutsch connector of the remote controller to the main cooling unit

(8’ length of wiring is provided).

3)

Connect the wiring from the vehicle’s power source to the ProCool-R remote controller:

From a fused 12V DC power source (25 Amp minimum), connect the supplied wiring

from the remote controller (red wire positive; black wire negative) to the power source.

OPERATING INSTRUCTIONS:

With the power switch on the remote controller in the OFF position and the cooling switch of the 

remote controller in the zero percent (0%) position:

1)

Remove the cap of the main cooling unit and fill with 

Procool Solution

 (using 

anything

 

other than distilled water may cause damage to the unit and will void your 

warranty).

2)

Connect a COOLSHIRT hose and shirt to the main cooling unit.  Turn the power from the

“off” to the “on” position.

3)

Observe the water level in the water tank and add additional 

solution

 as required

 

as air 

is purged from the system.  The purging could take several minutes.  Put the cap

 

back 

on securely.

4)

To start the cooling process, select either 50% or 100% on the remote controller switch.

PROCOOL R

© 2014 COOLSHIRT SYSTEMS, 170 Andrew Drive, Stockbridge GA 30281

Office : 800-345-3176                           Fax: 678-289-4325 

 www.coolshirt.com

Отзывы: