6 CG-1600i-RM – Product Manual
www.coolgear.com
+5V 2-Pin Terminal
USB 2.0 Upstream Ports
USB 2.0 Downstream Ports
The CG-1600i-RM provides
a lockable terminal power
connector to supply 5V, 1A
power to each connected
USB devices.
Type-B connector from
upstream USB 2.0 port. It is
connected from host or
another USB 2.0 hub.
Powered by an industrial-
grade switching power
supply, and each
downstream port provides
full 500mA power to the
connected USB devices
1.3
Hub Installation
1.
Connect the AC power cord to HUB-1600i-RM 16-Port USB 2.0 HUB. The red
power LED will light on when HUB is receiving power. Connect the upstream
port cable to an unused USB port on your computer.
2.
After the software driver are loaded, you can find new “Generic USB Hub” in
Universal Serial Bus controllers under “Device Manager” of the “System
Properties” screen. (Go to “Device Manager” by selecting Start- Setting-
Control Panel- System Properties- Hardware- Device- Device Manager)
See
Checking Hub Installation
.
3.
Connect your USB devices to the downstream ports on the HUB-1600i-RM
USB 2.0 HUB. The green USB status LED will illuminate when your USB
devices connected to one of the USB ports successfully.
1.4
Checking the Hub Installation
To check the USB hub installation in Windows device manager, please follow the
following steps:
1.
Click
Start
2.
Click
Control Panel
3.
Click
System
4.
Click
Device Manager
button
5.
Double Click
Universal
Serial Bus Controller
6.
Double click
Generic
USB Hub
, the
message will show
that this device is
working properly
Figure 5
