16
17
Dehumidifier
ION button (on
some models)
Description
Function
Press to activate the ionizer. Anions ar automatically generated by
ionization. The anions deactive the airborne chemical vapors and dust
particles. Press it again to stop the function.
Display
Shows the set % humidity level from 35% to 85% or auto start/stop time
(0~24) while setting, then shows the actual (±5% accuracy) room %
humidity level in a range of 30% RH (Relative Humidity) to 90% RH
(Relative Humidity).
NOTE: When one of the above malfunctions occurs, turn off the unit, and
check for any obstructions. Restart the unit, if the malfunction is still
present, turn off the unit and unplug the power cord. Contact the
manufacturer or its service agents or a similar qualified person for service.
Error Codes and Protection Code:
AS - Humidity sensor error
Unplug the unit and plug it back in. If error repeats, call for service.
ES - Tube Temperature sensor of the evaporator error
Unplug the unit and plug it back in. If error repeats, call for service.
P2 - Bucket is full or bucket is not in right position
Empty the bucket and replace it in the right position.(only available
for the unit with no pump feature.)
P2 - Bucket is full
Empty the bucket. (only available for the unit with pump feature.)
Eb - Bucket is removed or not in right position
Replace the bucket in the right position.(only available for the unit
with pump feature.)
Press to activate the dryer operation. Press it again to stop the fu nction.
DRYER button (on
some models)
Description
Function
Bucket Full Light
Glows when the bucket is ready to be emptied.
When forst builds up on the evaporator coils, the compressor will cycle off
and the fan will continue to run until the frost disappears.
Auto Defrost
Auto Shut Off
The dehumidifier shuts off when the bucket is full, or when the bucket is
removed or not replaced in the proper position.
For some models, the fan motor will continue to run for 30 seconds.
Wait 3 minutes before resuming operation After the unit has stopped, it can
not be restart operation in the first 3 minutes.This is to protect the unit.
Operation will automatically start after 3 minutes.
Check filter feature
The system starts to count the time once the fan motor operates. The check
filter feature can be only activated when the accumulated operation time
achieves 250 hours or more. The Reset light (Clean filter indicator light)
flashes at one time per second, after finishing clean the air filter, press the
Filter button and the Reset light (Clean filter indicator light) goes off.
Setting the Timer
• When the unit is on, first press the Timer button, the Timer Off indicator
light illuminates. It indicates the Auto Stop program is initiated. Press it
again the Timer On indicator light illuminates. It indicates the Auto Start
is initiated.
• When the unit is off, first press the Timer button, the Timer On indicator
light illuminates. It indicates the Auto Start program is initiated. Press it
again the Timer Off indicator light illuminates. It indicates the Auto Stop
is initiated.
• Press or hold the UP or DOWN button to change the Auto time by
0.5hour increments, up to 10 hours, then at 1 hour increments up to 24
hours. The control will count down the time remaining until start.
• The selected time will register in 5 seconds and the system will
automatically revert back to display the previous humidity setting.
• When the Auto Start & Auto Stop times are set, within the same program
sequence, Timer On Off indicator lights illuminate identifying both On
and Off times are now programmed.
• Turning the unit On or Off at any time or adjusting the timer setting to
0.0 will cancel the Auto Start/Stop function.
• When LED display window displays the code of P2, the Auto Start/Stop
function will also be cancelled.
If the unit breaks off unexpectedly due to a power outage, it will restart with
the previous function setting automatically when the power resumes.
Auto-Restart
Other features
