Cookworks XB6598-WD, Инструкция по уходу и эксплуатации

Страница: 4 / 7

Issue 1 29/6/2017 4
To use
1.
Place the kettle and stand on a stable, flat, heat resistant surface
and away from surfaces that may be damaged by steam.
2. Fully unwind the cable from the stand and plug in. For safety do
not allow the cable to dangle over the edge of units.
3. Remove the kettle from the stand; remove the lid and fill to the
required level using the markings on the clear water gauge as a
guide. Do not fill past the MAX (1.7 litre / 7 cups) or below the
MIN (1 litre / 4 cups) level.
4. Close the lid fully until it clips into place and ensure that the
switch is in the off position (lift switch up) before replacing on the
stand.
5. Turn the kettle so that the spout faces away from you and switch
the kettle on by pressing the switch downward (I). The kettle will
start to operate and the power indicator (at the base of the water
gauge) will illuminate.
6. When the water boils, the kettle will switch off automatically and
the indicator light will go off.
7. To stop or interrupt the boiling process, switch the appliance off
by lifting the switch up before removing the kettle from the stand.
Notes:
 Before using for the first time, fill the kettle to the maximum
level, bring to the boil and then discard water. Repeat this step
two further times.

This kettle is fitted with a safety device that automatically
switches off the heater element if the appliance is inadvertently
switched on when empty or if it boils dry. In this case allow the
kettle to cool completely (minimum 15 minutes) before refilling
with cold water. The kettle will resume operation after refilling.