PRIOR TO INSTALLATION
• Read all installation instructions carefully before starting installation.
• Remove charger carefully from carton. Save all packaging materials for subse-
quent shipment or in case of concealed shipping damage.
• Remove all loose packaging and accessories.
• It is the responsibility of the installer to comply with all federal, state and local
codes.
• Any installation not matching the requirements discussed in this manual will
automatically void the product’s warranty.
INSTALLATION
• The FlashPak PTDS can be installed on top of, or recessed into a flat, level
countertop or shelving unit, being careful to maintain at least two inches of
clearance on all sides and six inches below the unit for cooling. (Six inches
below is not required for top of counter or top of shelf installation)
• When installing the FlashPak PTDS in a drop in, or recessed application, allow
adequate clearance for the rear air vents and power cord.
• PTDS should be plugged into a grounded 120V or 208-240V (depending on the
model purchased), single-phase receptacle. Check rating plate on the Charger to
verify correct voltage.
NOTE: Each PTDS should be connected to its own DEDICATED circuit.
They should not be connected to circuits sharing compressors or other heavy
current draw devices.
• Do not move the FlashPak PTDS when it is electrically connected.
OPERATING INSTRUCTIONS
• Make sure that your FlashPak PTDS is plugged into an energized circuit as
described in the previous section. This should be a dedicated circuit, not shared
with any devices utilizing motors, compressors, or components requiring a
heavy current draw.
• The FlashPak PTDS is turned on by pressing the “POWER” button on the front
of the membrane panel. An LED will illuminate indicating that the FlashPak
PTDS is turned on and ready for use.
• Place a CookTek approved bag on each FlashPak PTDS.
• The red “CHARGING” LED will illuminate indicating that the bag is charging.
Do Not Remove
the bag from the FlashPak PTDS while the red LED is illumi-
nated. The bag may not fully charge resulting in a lower pizza delivery temper-
ature.
NOTE: You will hear three loud “BEEPS” if you remove the bag
before it is fully charged.
• If the red “CHARGING” LED does not illuminate, remove and reposition the
bag.
4
