Cookson FDO-A10, Руководство пользователя

Страница: 12 / 14

MAINTENANCE SCHEDULE
CHECK AT THE INTERVALS LISTED IN THE FOLLOWING CHART.
ITEM PROCEDURE
EVERY EVERY EVERY
3 MONTHS 6 MONTHS 12 MONTHS
Drive Chain
Check for excessive slack.
Check & adjust as required.
Lubricate.*
X X
Sprockets Check set screw tightness
X X
Fasteners Check & tighten as required
X
Bearings/Shafts Check for wear & lubricate
X X
Gearbox - The gearbox on the motor operator is factory sealed, and non vented, and should not
require service for the life of the operator.
Brake Friction Material - The electromagnetic brake on the motor operator is factory adjusted,
and should not require service for the life of the operator. Should service be
required, the entire unit should be replaced.
* - Use SAE 30 Oil (Never use grease or silicone spray)
Do not lubricate motor. Motor bearings are lubricated and sealed at the factory.
Inspect and service whenever a malfunction is observed or suspected.
CAUTION: BEFORE SERVICING, ALWAYS DISCONNECT OPERATOR FROM POWER SUPPLY.
WHEN ORDERING REPAIR PARTS PLEASE SUPPLY THE FOLLOWING INFORMATION:
PART NUMBER - DESCRIPTION - MODEL NUMBER - JOB NUMBER
ADDRESS ORDER TO:
COOKSON ROLLING DOORS
2417 S. 50TH AVE
PHOENIX, AZ. 85043
(602) 272-4244
ATTN: CUSTOMER SERVICE
MOTOR OPERATOR MAINTENANCE
Operators require practically no special maintenance other than periodic checking to see that
mechanical parts where necessary are lubricated and the electrical components are free of dirt.
The Service Technician should familiarize himself/herself with the proper sequence of operation
and all related controls. Power to operator must be disconnected when removing or replacing
covers on electrical components, making adjustments, or performing maintenance.
12