Fast Eddy’s Model PG1000
6
ELECTRICAL SPECIFICATIONS
110 Volt, 60 Hz, single phase, 4 amp service required
All switches should be in the off position before plugging into proper receptacle
outlet
The fire pot igniter elements are 200 watts; the auger motor and burner induction
fan are 25 watts each.
MAINTENANCE
Use foil to cover drip pan and change after each use
Clean ash from unit after approximately 20 hours of use
If the cooker is stored outdoors care should be taken to insure that water does not
get into the hopper. Wood pellets expand greatly when wet and will jam your
auger system. A vinyl cover is highly recommended. It will also keep water out
of your ash pan and grease drain bucket.
When cleaning the inside of the cooker only use a scraper to knock off the heavier
debris. Empty and scrape out the ash pan. A shop vac comes in handy on the fire
pot side of the cooker. Be careful not to damage the wiring coming from the
thermocouple. The dark color it will get is what we call seasoned and actually
enhances the performance of the cooker. It’s much like a cast iron frying pan.
When washing the outside of the unit you may use a mild degreaser such as a
simple green or 409 type house hold cleaners. Industrial type degreasers may
damage the powder coat finish. The cooking grates are dishwasher safe. If using a
brush on cooking grates only use a stiff nylon or brass brush. Anything else may
damage the coatings.
If you start seeing a build up of sawdust in the bottom of the hopper, remove the
pellets and use a shop vac to remove the sawdust. Build up of sawdust will not
allow the feed system to send the proper amount of pellets needed to maintain the
desired set temperature.
If your cooker seems slow to start or not starting at all, clean the fire pot and try
again.
Assembly Instructions
Install the supplied casters into the bottom of the grill legs. Note there are two
locking (front) and two non locking (back) casters.
Locate shelf from the box under the grill and use a 5/16 driver and drill to
install on the right end of the grill using the screws supplied.
