Convision CC-6601-B, Руководство пользователя

Страница: 10 / 120

12
WDR Digital Sensor Day/Night H.264 Network Camera
13
WDR Digital Sensor Day/Night H.264 Network Camera
The camera is supplied without a lens. Lenses, such as auto iris,
CS-Mount and C-Mount, can be used.
1. Strip back about 8mm of the outer sheath of the auto iris lens cable.
2. Strip off about 2mm of the insulation of wires inside the lens cable.
̰
Lens
Note
ื
Using a DC auto iris lens is recommended to achieve the best
possible results from the camera.
ื
Please keep the lens clean.
ื
Foreign objects or fingerprints on the lens will result in inferior image
quality, especially in low light level conditions.
3. Remove the cover of the auto iris lens connection plug and solder the
wires to the connector pins inside the plug, as shown below.
4. Replace the auto iris lens connection plug cover. Remove the lens
protection cap and then attach the auto iris lens to the camera by screwing
it in clockwise.
5. Insert the connection plug connected to the auto iris lens cable into the
auto lens connector jack, which is located on the rear of the camera.
Pin No.
LENS
DC VIDEO
No.1 Pin Damping Coil- Red (power)
No.2 Pin Damping Coil+ NC
No.3 Pin Drive+ White (video signal)
No.4 Pin Dreve- Black (GND)
When using an auto iris lens
̰
Overview
Installation Procedures
̰