Receiver
Front Panel
①
Link LED:
When the system is in search mode
the LED
will flash repeatedly and when the system
is in signal linking mode it will slowly flash. When
the LED is on and no longer flashing it means a
connection has been established and audio/
video can then be sent.
②
Power button:
Press this button to power up the
system, when the LED is lit the system has been
turned on.
③
IR Sensor
④
ID:
Press this button along with Transmitters “ID”
button for two seconds to connect the systems.
Before they left the factory the systems were
already set up so there is no need for the user to
reset the connection unless the systems cannot
link up properly. Press the ID button for more than
ten seconds to switch between Broadcast and
Unicast mode. When the green LED is on it means
the system is in Unicast mode and when the Red
LED is lit the system is in Broadcast mode. The
default mode for this system is Unicast and it is
recommended to use this for home use. It is not
necessary to press both the Transmitter and
Receiver buttons at the same time.
