General Safety
Please read these instructions before
using the fan and keep for future
reference.
This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been
given supervision or instruction in using
the appliance by a person responsible
for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
Do not poke anything through the
ventilating slits.
Assemble the fan completely before
use.
Always use the fan in an upright
position. Stand it on a firm, solid,
horizontal base (not on thick pile
carpets).
Clean the air inlets and outlets at regular
intervals to prevent airflow reduction
(refer Maintenance section).
For indoor use only. Do not use this fan
outdoors, or on wet surfaces. Do not
use the fan near flammable areas or
substances.
Electrical Safety
Before connecting your electrical power
cord to a power outlet, check that the
fan voltage is the same as your power
supply. The fan voltage will be stated on
the rating label.
Make sure that the fan never comes into
contact with water.
Never turn the fan on if the lead is
damaged or if the fan’s casing is
obviously damaged.
If the power supply cord is damaged it
must be replaced by the manufacturer, a
service agent or similarly qualified
persons in order to avoid a hazard.
Do not pull the fan along by the power
cord. Always uncoil the power cord
completely.
Always turn the fan off and unplug from
the power socket when not in use.
SEELEY INTERNATIONAL –
OWNER’S MANUAL
2
SAFETY
Component List
1. Upper Fan
2. Middle Fan
3. Lower Fan
4. Handle
5. Upper Fan Control Knob
6. Middle Fan Control Knob
7. Lower Fan Control Knob
8. Power Cord & Plug
9. Base Stand
10. Locking Nut
11. Decorative Strips
12. Decorative Plate
Assembly
Unpack the fan and check that you have
all of the components.
Clip the decorative strips into the fan
base, ribbed side downwards.
Fix the base stand to the decorative
plate, pushing down firmly to lock into
place.
Remove the locking nut from the fan.
Align the holes on the base to the
locating pips on the fan, then fix firmly
with the locking nut (Fig 2).
ASSEMBLY
1
2
Rib side down
Align pips to holes in base
1
2
7
8
3
4
5
6
9
10
11
12
1
CTF04
®
